1000HS Epoxy Primer- 1.5 Gallon Kit
1000HS Epoxy Primer- 1.5 Gallon Kit
1000HS Epoxy Primer- 1.5 Gallon Kit
1000HS Epoxy Primer- 1.5 Gallon Kit
  • Load image into Gallery viewer, 1000HS Epoxy Primer- 1.5 Gallon Kit
  • Load image into Gallery viewer, 1000HS Epoxy Primer- 1.5 Gallon Kit
  • Load image into Gallery viewer, 1000HS Epoxy Primer- 1.5 Gallon Kit
  • Load image into Gallery viewer, 1000HS Epoxy Primer- 1.5 Gallon Kit

1000HS Epoxy Primer- 1.5 Gallon Kit

Regular price
$115.00
Sale price
$115.00
Regular price
$125.00
Sold out
Unit price
per 

Simiron 1000 HS Primer is a 100% solids, zero VOC, blush resistant and low viscosity epoxy primer that delivers excellent surface wetting, penetration and extended open time to promote adhesion. It’s ideal for use with other Simiron coatings, as well as, quartz and chip broadcast systems.

APPLICATION EQUIPMENT: Squeegee – Flat rubber squeegee with EPDM rubber blade. Rollers – Use a 3/16” nap, woven, shed-resistant roller cover with phenolic core for back-rolling. PREP: Bare concrete and primed concrete must be clean, dry and free of contaminates such as dirt, dust, grease, oil and other foreign materials. A suitable moisture barrier must be in place for concrete slabs on-grade. If a moisture vapor barrier is not in place, seasonal variations in ground moisture can cause excessive hydrostatic pressure regardless of results measured prior to coating application. Concrete should be shot blasted or diamond ground

MIXING: One gallon kit comes pre-measured and is ready to mix. Mix contents of each component thoroughly with low speed mixer. Then pour both Base and Activator into a clean five gallon mixing bucket and mix with high speed drill for 3 minutes, be sure that material is mixed thoroughly before using. There is no induction time required and material can be used immediately. APPLICATION: Application: Pour mixed material onto floor in a long bead approximately 8-12 inches wide. Apply primer by flat squeegee at the rate of 200 – 500 ft²/gallon at 3 – 8 mils. Back-roll material and ensure that the coating is pore-free and pinhole-free and provides uniform and complete coverage over the entire concrete substrate. If necessary, apply an additional coat to ensure that the coating is pore-free and pinhole-free and provides uniform and complete coverage over the entire concrete substrate. Do not drain or scrape remaining material in bucket.

 

Data Sheet:

SIM_1000HS_ProductDataSheet_8.5x11_062822_vFIN.pdf (simiron.com)

 

 

 

Net Orders Checkout

Item Price Qty Total
Subtotal $0.00
Shipping
Total

Shipping Address

Shipping Methods